TINYCONTROL current sensor SCT up to 30A for LAN controller LK3 and LK4

This non-invasive current sensor clamped around the supply line can measure a load up to 30 Amps, and allow you to calculate how much current pass through it. It can be useful for building your own energy monitor or for building an over-current protection device for an AC load. This current clamp can be used to detect a current of up to 30 A. Simply clip it around the current source that you wish to measure and it will produce a (very) small AC voltage proportional to the current. The cable is terminated on one end with a standard 3.5 mm jack (like a headphone jack). Use this to build your own energy monitor and keep your power usage down, or use it to to build an over-current protection device for an AC load.

Specifications

Input Current: 0-30 A
Maximum diameter of measured conductor: 12 mm
Output Mode: 0-1 V (AC)
Output Plug: 3.5 mm
Cable Length: 1 m
Weight: 45 g

The method of connecting the sensor to the LAN driver v3 can be found in the manual [CZ].