Brass battery terminal 600AMP PLUS

Brass battery terminal, 1 piece, with a wing nut instead of a screw; a car battery terminal for voltages up to 12V.The terminals are made of brass, which ensures good electrical conductivity and resistance to corrosion.These clamps are fitted as standard in most motor vehicles. Before fitting or replacing the clamps, the battery terminals must be thoroughly cleaned to ensure a good contact and correct charging, thereby preventing any power loss.Butterfly nut thread: M8x15mmInstructions for use:Remove the old terminals from the power cables. Clean the cables thoroughly to ensure the best possible connection.Loosen the clamping screws on the terminals. Insert the cables into the terminals, then tighten both clamping screws evenly so that the cables are held firmly in place and do not move. Fit the clamps to the car battery and tighten the bolts firmly.NOTE:Do not drive the clamps into the car battery when fitting them, to avoid damaging the battery.